User's Manual

NURIT 8400
22 Installation Manual
10. Connecting to a LAN
Some models of the NURIT 8400 can be connected to a Local
Area Network (LAN). Depending on the specific model, the
NURIT 8400 can be connected to either an RS-485 LAN or a
10BaseT Ethernet LAN.
To connect the NURIT 8400 to an Ethernet LAN:
1. Disconnect the AC/DC Power Adapter from the electrical
power outlet.
2. Remove the cable compartment cover, as described in
“Removing and Replacing the Cable Compartment Cover” on
page 14.
3. Connect the Ethernet Adapter cable to the ENET connector
on the connections panel.
4. Connect the other end of the Ethernet Adapter cable to one
end of the network cable.
5. Connect the other end of the network cable to a network
wall outlet, switch, or other compatible network device.
Figure 10-1 Typical Ethernet/RS-485 LAN Connection
6. Replace the cable compartment cover, as described on
page 15.
7. Reconnect the AC/DC Power Adapter to the electrical
power outlet.