User's Manual

NURIT 8400
24 Installation Manual
11. Connecting an External PIN Pad
To connect an external PIN pad to the NURIT 8400:
1. Disconnect the AC/DC Power Adapter from the electrical
power outlet.
2. Remove the cable compartment cover, as described in
“Removing and Replacing the Cable Compartment Cover” on
page 14.
3. Connect one end of the connector cable (supplied with the
terminal) to the PIN connector on the rear panel of the
NURIT 8400.
4. Verify that the other end of the connector cable is
connected to the PIN pad.
5. Replace the cable compartment cover, as described on
page 15.
6. Reconnect the AC/DC Power Adapter to the electrical
power outlet.
Figure 11-1 PIN Pad Connection
Caution
Only use the assigned connection port, labeled PIN for
PIN pad connections.
PIN