User's Manual

NURIT 8400

26 Installation Manual

To connect an RS-232 peripheral device to the

NURIT 8400:

1. Disconnect the AC/DC Power Adapter from the electrical

power outlet.

2. Remove the cable compartment cover, as described in

“Removing and Replacing the Cable Compartment Cover” on

page 14.

3. Connect a peripheral device to one end of its adapter cable.

4. Connect the other end of the adapter cable to either the

COM1 or COM2 (model-dependent) connector on the

connections panel.

5. Replace the cable connection cover, as described on

page 15.

6. Reconnect the AC/DC Power Adapter to the electrical

power outlet.

Figure 12-1 Peripheral Device Connection

1 Signature capture device 2 PC

3 Barcode reader 4 Electronic scale

5 Check reader 6 Contactless reader

PWR

COM1

COM2