User's Manual

NURIT 8400
Installation Manual 35
16. Installing and Removing the Battery
To install the battery:
1. Remove the battery/SAM-SD/MMC compartment cover, as
described in “Removing and Replacing the Battery/SAM-SD/MMC
Compartment Cover” on page 33.
2. If necessary, remove the SAM-SD/MMC adapter, as
described in “Installing and Removing the SAM-SD/MMC
Adapter” on page 38.
3. Hold the battery at a 30° angle, with the battery power
plug, facind down, into the compartment, making sure that
the side with the arrow pictogram is facing upward.
4. Slide the two tabs on the front of the battery into the slots
on the front wall of the battery compartment.
5. Slide the battery forward and down, until it snaps into
place.
6. If necessary, install the SAM-SD/MMC adapter, as described
in “Installing and Removing the SAM-SD/MMC Adapter”
on page 38.
7. Replace the battery/SAM-SD/MMC compartment cover, as
illustrated in Figure 15-2 on page 34.
Figure 16-1 Installing the Battery