User's Manual
NURIT 8400
36 Installation Manual
To remove the battery from the NURIT 8400:
1. Remove the battery/SAM-SD/MMC compartment cover, as
described in “Removing and Replacing the Battery/SAM-SD/MMC
Compartment Cover” on page 33.
2. If necessary, remove the SAM-SD/MMC adapter, as
described in “Installing and Removing the SAM-SD/MMC
Adapter” on page 38.
3. Slide the battery in the direction of the arrow, gently
detaching it from its socket.
4. Remove the battery.
Battery Maintenance
• The supplied high-performance, smart Lithium-Ion battery
provides 7.2 V at 2200 mAH (minimum) capacity.
• When fully discharged, the battery fully recharges within
six hours while installed in the terminal.
• The terminal can be connected to an AC/DC power supply
indefinitely without causing damage to the battery.
• In typical use, the life span of the battery exceeds 500
charge cycles, after which, operating time decreases slowly.
• The battery has a self-discharge rate. It loses approximately
1% of its charge per day when not in use. Replace the
battery when the charge capacity is too weak for normal
operation.
• Remove the battery from the terminal if you do not intend
to use your NURIT 8400 for an extended period of time.
Caution
Take care when installing the battery. If installed
incorrectly, it may explode. Use only a VeriFone
supplied battery.
Warning
Do not break open or damage the casing of the battery.
Warning
Do not dispose of the NURIT 8400 Li-Ion smart battery
in a fire. Li-Ion batteries must be recycled or disposed
of properly. Do not dispose of Li-Ion batteries in
municipal waste sites.