User's Manual

NURIT 8400

42 Installation Manual

6. Close the SAM cardholder.

7. Lock the cardholder by sliding the cardholder locking clasp

in the direction indicated by the engraved arrow to the

LOCK position.

8. Replace the battery/SAM-SD/MMC compartment cover, as

described on page 34.

Installing an SD/MMC Card

To install an SD/MMC card:

1. Remove the battery/SAM-SD/MMC compartment cover, as

described in “Removing and Replacing the Battery/SAM-SD/MMC

Compartment Cover” on page 33.

2. Hold the SD/MMC card directly above the SD/MMC card

slot, with the metal contacts facing down and the narrow

edge with the beveled corner pointing towards the slot

opening.

3. Slide the SD/MMC card into the cardholder.

4. Press down on the SD/MMC card while sliding it into the

slot.

Figure 17-5 SD/MMC Card

5. Replace the battery/SAM-SD/MMC compartment cover, as

described on page 34.

Note

Make sure that you first slide the end closest to the

chip on the card into the grooves of the holder.

1 SD/MMC card 2 Metal contacts

3 Beveled corner