User's Manual

NURIT 8400
Installation Manual 43
Installing a SIM card
To install a SIM card:
1. Remove the cables cover, as described in “Removing and
Replacing the Cable Compartment Cover” on page 14.
2. With a screwdriver, lift the tab of the SIM card cover.
Figure 17-6 Lifting the SIM Card Cover
3. Slide the cardholder locking-clasp in the direction indicated
by the engraved arrow to the OPEN position, as illustrated in
Figure 17-3.
4. Lift the cardholder on its hinge to an upright position.
5. Hold the SIM card so that its chip side is facing down
towards the contacts on the reader.
6. Insert the end closest to the chip on the SIM card into the
cardholder, as illustrated in Figure 17-4.
7. Close the SIM cardholder.
8. Lock the cardholder by sliding the cardholder locking clasp
in the direction indicated by the engraved arrow to the
LOCK position.
9. Replace the SIM card cover, by holding the SIM card cover
at a 30° angle and putting the tabs into the tab slots.
Note
Make sure that you first slide the end closest to the
chip on the card into the grooves of the holder.