Installation guide

TERMINAL SETUP

Install Paper Roll

NSTALLATION GUIDE 15

The Omni 3200SE/3210SE printer uses a roll of single-ply, thermal-sensitive paper

58 millimeters (2.25 inches) wide and approximately 25-33 meters (82-108 feet)

long.

To Install a Paper Roll

1 Turn on the terminal. The LED indicator will blink on and off, indicating that the

printer needs paper.

2 Press the button on the side of the terminal to unlatch the paper roll cover,

then rotate the cover up and back (see Figure 7).

Figure 7 Printer Roll Cover Release Button

3 If present, remove a partial roll of paper from the printer tray by lifting it out.

4 For new rolls of paper, loosen the glued leading edge of the paper or remove

the protective strip.

5 Hold the roll so the paper feeds from the

bottom

of the roll.

6 Optionally, insert the orange plastic spindle into the paper roll.

7 Place the paper roll into the paper roll cradle (see Figure 8).

WARNING

Low-quality paper may cause the printer to operate poorly. To order high-quality

VeriFone paper, refer to Accessories and Documentation.

CAUTION

Store thermal paper in a dry, dark area. Handle thermal paper carefully: impact,

friction, temperature, humidity, and oils affect the color and storage characteristics

of the paper.

Never load a roll of paper with folds, wrinkles, tears, or holes at the edges or in the

print area.