Specifications

Remote Diagnostics and Debugging
Performing Remote Diagnostics 107
Initiating a Remote Diagnostics Session
The procedure described in Table 26 below explains how to initiate a
remote diagnostics session from an Omni 3200 terminal over a
telephone line connection. As in previous procedure descriptions, it
starts from the System Prompt (displayed when the terminal is in
System Mode).
Table 26 Remote Diagnostics Over a Telephone Line
Display Action
1.
SYSTEM=
(Firmware ID) To initiate a remote diagnostics session, press [8].
2.
REMOTE DIAG
(or)
*T=
The message
REMOTE DIAG
is displayed briefly.
If no telephone number is stored in the *T= record, the
*T=
prompt appears asking you to enter this number
into the CONFIG.SYS file. To do this, you simply key
in the value from the core keypad and press [FUNC/
ENTER].
If the telephone number of the remote diagnostic
computer has already been stored in the CONFIG.SYS
file, the terminal automatically starts the dial-up
procedure.
O3200 RM Book.book Page 107 Thursday, April 29, 1999 3:48 PM