Specifications

Remote Diagnostics and Debugging
Descriptions of Diagnostic and Debugging Commands 125
Command Packet Received by Terminal:
<FFh> <55h> <count> S <CRC1> <CRC2>
Response Packet Sent by Terminal:
<FFh> <55h> <count> S <CRC1> <CRC2>
T — Configure Diagnostics Parameters (Debugger Only)
The T command sets the diagnostics status byte, which is also
reported as part of the L and I command response packet.
Bit
Input/Output Setting Description
Bit 0 Output 1 = If the source file name has
changed because the previous
F command was issued
0 = Otherwise.
Bit 7 Input 1 = Set stepping on EM
instructions
0 = Set stepping on source lines.
Command Packet Received by Terminal:
<FFh> <55h> <count> T <status byte> <CRC1> <CRC2>
Response Packet Sent by Terminal:
<FFh> <55h> <count> T <CRC1> <CRC2>
O3200 RM Book.book Page 125 Thursday, April 29, 1999 3:48 PM