Specifications

Performing System Mode Operations
About System Mode Procedure Descriptions 33
Because additional information is required to set up and perform
remote operations such as downloads and remote diagnostics, remote
System Mode functions are described in other sections: “Performing
Downloads” and “Remote Diagnostics and Debugging.”
• The following three procedures are described in the section,
“Performing Downloads:”
[0] Perform a download by telephone
[*] Upload software to another terminal
[#] Receive a direct software download
• The following procedure is described in the section, “Remote
Diagnostics and Debugging:”
[8] Initiate remote diagnostics
About System Mode Procedure Descriptions
The procedure descriptions provided below explain how to perform
each of the System Mode functions listed in Table 3.
Each procedure description starts at the System Prompt.
As you may recall, there are two ways to display the System Prompt,
depending on whether or not an application has already been loaded
into the memory of your terminal (see Table 4 below):
• If the message
DOWNLOAD NEEDED
is displayed, press
[CLEAR] to enter System Mode.
• If an Application Prompt is displayed, press [FUNC/ENTER] and
the [7] key simultaneously. Then, key in the System Password
and press [FUNC/ENTER] again.
The default System Password, which is pre-set at the factory, is
[1] [ALPHA] [ALPHA] [6] [6] [8] [3] [1]
O3200 RM Book.book Page 33 Thursday, April 29, 1999 3:48 PM