Specifications

Performing System Mode Operations
Entering System Mode 35
Text presented in the
Action
column of a procedure description:
• Describes the current step and context of the procedure,
• Indicates the entries you must enter using the core keypad in
response to a currently displayed prompt or message,
• Provides additional explanations or information about the steps of
the particular System Mode function.
Note: Entering and leaving System Mode restarts the terminal
application (assuming that an application has already been
downloaded into the terminal’s memory) and terminates any
transaction that has not been completely processed.
Entering System Mode
To enter System Mode after you have connected the Omni 3200
terminal to a power source, follow the procedure described in Table 4.
Table 4 Enter System Mode
Display Action
1. (Application Prompt)
(or)
DOWNLOAD NEEDED
If an Application Prompt is displayed, press [FUNC/
ENTER] and [7] simultaneously to enter System Mode.
If the system message
DOWNLOAD NEEDED
is
displayed, press [CLEAR] to enter System Mode.
2.
SYSTEM PASSWORD?
If an Application Prompt was displayed in Step 1 (that
is, if an application has already been downloaded into
the terminal memory), key in the System Password and
press [FUNC/ENTER].
The default password, which is pre-set at the factory, is
[1] [ALPHA] [ALPHA] [6] [6] [8] [3] [1].
NOTE: Until an application has been downloaded into
the terminal memory (that is, if the
DOWNLOAD
NEEDED
message is displayed on your terminal), no
password is required to enter System Mode.
O3200 RM Book.book Page 35 Thursday, April 29, 1999 3:48 PM