Specifications

Omni 3200 Reference Manual
50 [8]: Initiate Remote Diagnostics
The Keyed File Character Set
The keyed file character set consists of 95 ASCII characters from 00h
to 5Fh (hexadecimal), or 0 to 95 (decimal). Characters outside this
range should not be used and cannot be entered using the keyed file
editor.
Note: For a complete list of the ASCII characters supported by the
Omni 3200, as well as their decimal and hexadecimal equivalents,
please refer to Appendix B.
[8]: Initiate Remote Diagnostics
Press [8] in System Mode to initiate a remote diagnostics session
between the Omni 3200 terminal and a remote host computer over a
telephone line.
Note: For detailed information about performing remote
diagnostics, please refer to the section, “Performing Downloads.
5.
RECALL?
When you are adding, deleting, or modifying variables,
press [CLEAR] to return to the
RECALL?
prompt.
NOTE: If you are editing a record, and if you press
[CLEAR] before you press [FUNC/ENTER], the
updated value is not saved.
When the
RECALL?
prompt is displayed, press
[CLEAR] to exit the keyed file editor and return to the
System Prompt.
6.
SYSTEM=
(Firmware ID) At the System Prompt, you can select another System
Mode function, or press [CLEAR] again to exit System
Mode and restart the terminal application.
Table 14 Edit a Keyed File
Display Action
O3200 RM Book.book Page 50 Thursday, April 29, 1999 3:48 PM