Specifications

Performing System Mode Operations
[9]: Test the Thermal Printer 51
[9]: Test the Thermal Printer
Press the [9] key in System Mode to initiate a test of the Omni 3200
integrated thermal printer. The test prints out all 95 ASCII characters
in the printers character set (32 to 126 decimal) in three different
character sizes:
Normal width / normal height (42 characters per line)
Double width / normal height (21 characters per line)
Double width / double height (21 characters per line)
The test ends automatically after about ten seconds by printing
message
Test Completed
.
Note: Before you start this test, be sure that a roll of thermal paper
is loaded in the integrated printer.
Table 15 Test the Thermal Printer
Display User Entry
1.
SYSTEM=
(Firmware ID) Be sure that a roll of thermal paper is loaded in the
printer.
Press [9] to start the integrated printer test.
2.
INT. PRINT TEST
Three sets of 95 ASCII characters are printed out
consecutively, each with a different character size.
During the test, the
INT. PRINT TEST
message is
displayed.
The print test ends automatically after a few seconds
and the System Prompt is displayed.
3.
SYSTEM=
(Firmware ID) To exit System Mode, press [CLEAR].
O3200 RM Book.book Page 51 Thursday, April 29, 1999 3:48 PM