Specifications

Performing System Mode Operations
[ALPHA]: Change the System Password 53
Note: The procedure described below assumes that the default
System Password is still valid for your Omni 3200 terminal.
Table 16 Change the System Password
Display Action
1.
SYSTEM=
(Firmware ID) Press [ALPHA] to initiate the password change
procedure.
2.
CHANGE PASSWORD
The terminal displays the
CHANGE PASSWORD
prompt briefly and then asks you to key in the existing,
or old, password.
3.
OLD?
Key in the current System Password and press [FUNC/
ENTER].
If you enter an invalid password, the
OLD?
prompt
continues to be displayed until you:
– Enter the correct password, or
– Press [CLEAR] to cancel the operation.
When the password is validated, you are then prompted
to key in the new password.
NOTE: A System Password is alphanumeric and must
be 10 characters (or less) in length.
4.
NEW?
Key in the new password and press [FUNC/ENTER].
5.
AGAIN
(or)
NEW?
The
AGAIN
prompt asks you to confirm the new
password by entering it again. When you have done
this, press [FUNC/ENTER].
If you re-entered the password correctly, the
modification takes effect immediately and the terminal
returns to the System Prompt.
If you key in the new password incorrectly, the
NEW?
prompt appears, asking you to repeat the entry one
more time, or until it matches your the original entry.
Repeat Steps 4 and 5.
O3200 RM Book.book Page 53 Thursday, April 29, 1999 3:48 PM