Specifications

Performing System Mode Operations
[BACKSPACE]: Initiate Destructive Memory Test 55
3.
MEMORY TEST
(or)
MEMORY -OK-
(or)
MEMORY ERROR
The memory test runs continuously until you stop the
test (see below).
During the test, the message displayed on the terminal
screen alternates between
MEMORY TEST
and
MEMORY -OK-.
The message
MEMORY -OK-
indicates that no
memory problems were detected during the previous
test.
NOTE: If a problem is detected during the test, the
error message
***BAD RAM***
is displayed. If you
see this message, contact your local VeriFone
representative for assistance.
To stop the test, press any key while the
MEMORY
-OK-
message is displayed. The message
MEMORY
ERROR i
s then displayed to indicate that the contents
of the memory were erased during the test.
Press [CLEAR] to return to the System Prompt.
4.
SYSTEM=
(Firmware ID) Because contents of the Omni 3200 application
memory (SRAM) were cleared during the test, you can
now proceed to select the appropriate System Mode
function and download a new application program.
NOTE: For more information about application
downloads, please refer to the section “Performing
Downloads.”
Table 17 Initiate Destructive Memory Test
Display Action
O3200 RM Book.book Page 55 Thursday, April 29, 1999 3:48 PM