Specifications

System Messages
126 OMNI 37XX REFERENCE MANUAL
This message displays when a system mode function queried an internal device
that is busy. This message can also occur if you entered system mode with an
application running.
For example, if the application opened the magnetic stripe card reader and you try
to invoke the card reader diagnostic through
MAG CARD READER F4 in
SYSMODEMENU5, the attempt fails and this message appears.
Restart the terminal and enter system mode before the application starts.
The operating system is unable to start the application specified in the *GO
variable for the following reasons:
• No application resident in the terminal.
• The *GO variable is not set in the Group 1 CONFIG.SYS file.
• The application file specified in the *GO variable does not exist in Group 1.
(The *GO variable cannot specify an application file stored in a file group other
than Group 1.)
• The application or a shared library used by the application either does not
exist or is not authenticated. All executables must be authenticated to run on
the terminal.
• There is not enough memory available to run the application requested in the
*GO variable.
A corrupt file is detected in the flash file system during terminal start up, after
power-on, or during restart. This message may indicate a hardware problem or
the error condition may be resolved through another download of the file.
DOWNLOAD NEEDED
FLASH CHKSUM ERROR