Specifications

System Messages
O
MNI 37XX REFERENCE MANUAL 133
When you invoke a local system mode diagnostic test of the magnetic stripe card
reader, status information appears for data track (TRK1, TRK2, and TRK3) on a
magnetic stripe card.
To perform this test, select
MAG CARD DIAG F4 in SYS MODE MENU 5 and swipe a
magnetic stripe card through the card reader:
• NO DATA or VALID DATA: A successful test of the magnetic-stripe card reader
displays for each track. Actual data stored on data tracks does not display.
• An error condition generates one of the following error messages for each
track with an error:
• NO DATA
• NO START
• NO END
• LRC ERR
• PARITY ERR
• REVERSE END
Press the cancel key to end the local diagnostic test of the card reader.
If you are using the file compression module in DMM, information similar to what
is shown above appears when an error occurs during file extraction from a
downloaded ZIP archive. Note the error number and error codes (
xxxxx and
yyyyy) and try to download the archive again.
If you are using the file compression module in DMM, information similar to what
is shown above appears when a compressed file archive downloaded to the
terminal decompresses (unzipped), and the files extracted from the archive.
TRK1:
TRK2:
TRK3:
** UNZIP Error n
xxxxxx
yyyyyy
UNZIP stuff.zip
myprog.out
mydata.txt
6x8.fon
10x14.fon
...