Specifications

TERMINAL SETUP
Install/Replace MSAM Cards
22 OMNI 37XX REFERENCE MANUAL
To change or install SAMs
1 Remove the power cord from the back of the terminal.
2 Place the terminal upside-down on a soft, clean surface to protect the lens
from scratches.
3 To access the MSAM holders, remove the optional locking screw and remove
the MSAM compartment door (see Figure 7).
Figure 7 MSAM Compartment Door and Optional Locking Screw
4 Each holder consists of a hinged tilt-up cover attached to a connector base.
Unlock a holder by sliding its locking plate to the unlocked position, shown by
the OPEN arrow (see Figure 8).
Figure 8 MSAM Holder Close-Up
5 Open the holder by pivoting the cover on its hinges away from its connector
base (see Figure 9).
Figure 9 Using an MSAM Holder
6 Remove any previously-installed MSAM card by sliding the card from the
cover.
MSAM
OPTIONAL
COMPARTMENT
DOOR
LOCKING
SCREW
OPENING THE
REMOVING A INSTALLING A CLOSING THE
MSAM HOLDER
SAM CARD SAM CARD MSAM HOLDER