Specifications

TERMINAL SETUP
Connect Optional Device(s)
O
MNI 37XX REFERENCE MANUAL 23
7 Install an MSAM card by aligning the card and carefully sliding it within the
guides on the cover until it is fully inserted.
8 Close the holder by pivoting the cover back to its connector base (see
Figure 9).
9 Lock each MSAM holder by sliding its locking plate, as shown by the LOCK
arrow, until the plate stops (see Figure 8).
10 Replace the MSAM compartment door and reinstall the optional locking screw
(see Figure 7).
Connect
Optional
Device(s)
The Omni 37xx supports some peripheral devices designed for use with electronic
point-of-sale terminals.
Use the two ports on the back panel to connect up to two optional devices.
The following sections discuss the most common optional devices supported by
this terminal.
Other optional devices may be supported. For more information, please contact
your VeriFone distributor.
NOTE
Before inserting the MSAM card, position it as shown in Figure 9, with the card’s
gold contacts facing the smart car reader end of the terminal. The holder
connector base has a set of contacts and a notch post on one corner to ensure the
MSAM card is positioned correctly when the cover is closed. The MSAM card has
a notch on one corner to ensure that it fits into the connector base in only one way.
CAUTION
Before connecting any peripheral device, remove the power cord from the back of
the terminal and be sure the LED is not lit. Reconnect the power cord only after
you are finished connecting the peripheral device(s). For complete information
about peripheral installation and use, refer to the user documentation supplied
with those devices.
Table 1 Optional Devices Supported
Optional Device Connection Port
Barcode PIN pad
CR 600 RS232
External LAN RS232
PIN Pad PIN pad
RS232 Electronic Cash Register RS232
NOTE
RS232-type devices do not work with the PIN pad port; PIN pad-type devices do
not work with the RS232 port. If an optional peripheral device does not function
correctly, check the port connection.