Specifications

TERMINAL SETUP

Connect Optional Device(s)

24 OMNI 37XX REFERENCE MANUAL

Connect PIN Pad,

Smart Card

Reader, or Bar

Code Wand

To Connect PIN Pad, Smart Card Reader, or Bar Code Wand

1 If necessary, insert the small modular plug on one end of the PIN pad cable

into the PIN pad’s modular jack. For a bar code wand, insert the RJ45-type

connector into the PIN pad serial port on the back panel.

2 If installing a PINpad 101, PINpad 201, or PINpad 1000, position and insert

the grommet to secure the cable connection.

If a cable is not already connected to the smart card reader or PINpad 501,

insert the small modular plug on one end of the interface cable into the

optional device’s modular jack.

3 Insert the larger RJ45-type connector on the other end of the PIN pad cable

into the PIN pad serial port on the terminal’s back panel.

Figure 10 provides an example of a smart card reader connection to a bar

code and PIN pad serial port.

Figure 10 Smart Card Reader Connection

Connect Check

Reader

The Omni 37xx terminal supports the CR 600 and CR 1000

VeriFone check

readers. Contact your VeriFone representative or visit the online store at

www.store.verifone.com for information on these devices. Figure 11 provides

an example of a peripheral connection to an RS232 port.

CAUTION

Check readers require a separate power source. Before connecting a check

reader or similar device, remove the power cord from the back of the terminal and

be sure the LED is not lit.