Specifications

SYSTEM MODE
System Mode Menus
O
MNI 37XX REFERENCE MANUAL 53
System Mode
Menu 7
In this menu, you can view file information for the RAM and Flash directories in
each file group.
IPP KEY LOAD F3
INTERNAL PIN PAD
KEY LOADING MODE
BYTES SENT 0
BYTES RCVD 0
END F4
Select this mode when using SecureKit or
programming from your PC to inject keys into your
terminal. In this mode, a pipe is opened through COM1
to the IPP to allow key loading.
Press the cancel key to stop the key load session;
press F4 when finished with the key load.
PRINTER DIAG F4
Printer ID M
Version 0SAT023
Status 22
Test F3
Paper Feed F4
When you select F4, the firmware ID and version, and
the printer status appear.
Press F3 to run the printer test. A print sample begins
that uses approximately 30.5 cm (12”) of paper. This
allows you to test the print quality and adjust your code
for print optimization.
See the
Verix Operating System Programmer’s
Manual
(VPN 19733) for specifics on application
development and the internal thermal printer.
Press F4 to run approximately 5 cm (2”) of paper
through the printer without printing. To exit this screen,
press the cancel key.
Table 13 System Mode Menu 6
Display Action
Table 14 System Mode Menu 7
Display Action
SYS MODE MENU 7
RAM DIRECTORY F3
FLASH DIRECTORY F4
↑
To test the IPP, select IPP DIAG F2. To test the IPP
key load, select
IPP KEY LOAD F3. To run printer
diagnostics and test the printer, select
PRINTER DIAG
F4
.
To return to the previous system mode menu, press
the PF1 key; to return immediately to
SYS MODE MENU
1
, or to quit any operation within this menu, press the
cancel key.