User`s guide

Emdeon Vx570 User’s Guide

Chapter 1: Install Your Equipment

Page 2

This material contains confidential, proprietary information. Unauthorized use or disclosure of the information is strictly prohibited.

Warnings!

• The Vx570 should be on an electrical protective device such as a UPS (uninterruptible power supply)

or a surge protection strip. Do not plug a Vx570 into a PoE (Power over Ethernet) switch.

• Refrain from frequently disconnecting and reconnecting the Vx570 from/to the power source.

• Keep the Vx570 away from anything that could damage the device, such as heavy unstable objects,

liquids (plants, coffeemakers, and so on), small children, etc.

• Do not place the Vx570 where it could easily fall, such as near the edge of a desk.

Insert Paper in the Printer

1. To open the printer, press down on the lever located on the side of the terminal to unlatch the

paper roll cover, then lift the cover up and back.

2. If necessary, loosen the glued leading edge of the paper or remove the protective strip from the

new roll of paper. Unwind the paper roll past any glue residue.

3. Drop the paper roll into the printer cavity such that the paper rolls under and up nearest to the

serrated tearing edge. This positioning ensures that the printable side is facing outward.

4. Close the paper cover, allowing a small bit of paper to extend outside of the printer cover.

Notes:

• You can press 3 from the Emdeon Welcome screen (see page 12) to advance the paper.

• A pink out-of-paper indicator line appears on the edge of the paper approximately 18 includes

before the end of the roll.