User Manual Part 2

Omni 3600 Installation Guide
14
Power Port
On the back of the Omni 3600 is one port—the power
port—identified by the lightning bolt icon shown at right.
Use this port to connect the Omni 3600 to the power
pack to recharge the battery through the unit
Connect Power Pack
To connect the Omni 3600 terminal to power:
1 Insert the round barrel connector (Figure 3) into the
power port (icon at right) on the back of the
terminal.
2 Insert the power cable into the power pack.
3 Plug the power pack into a wall outlet or surge protector.
NOTE
If the tamper-evident label or any component appears
damaged, immediately notify the shipping company and
your VeriFone distributor or service provider.
NOTE
Install a power surge protector to protect against
possible damage caused by lightning strikes and
electrical surges.