User Manual Part 3

23
Omni 3600 Installation Guide
Data transfers can also be performed through the Omni 3600
base (see Omni 3600 Base Communications Ports).
Installation
The Omni 3600 should arrive from manufacture with the
antenna attached. If unattached, use the following procedure
to install the antenna:
1 Locate the antenna port on the side of the Omni 3600
terminal.
2 Align the respective “notch” inside the antenna to the key
in the terminal (Figure 9).
3 Push gently on the center of the base of the antenna until
it locks in position.
Figure 9 Antenna Installation
NOTE
Never hold the unit by the antenna; doing so may break
the connection and void your warranty.