User's Manual Part 1

OMNI 3600 TERMINAL AND OMNI 3600 BASE INSTALLATION
Omni 3600 Terminal
12 OMNI 3600 REFERENCE MANUAL
The following are features of the smart battery:
• Two Li-ion cells
• A fuel gauge module
• monitors state of charge (voltage and current),
• communicates with the terminal (charge parameters and alarms to
indicate full discharge),
• determines full charge capacity (on charge cycle and uninterrupted
discharge cycle), and
• automatically shuts down when cell voltage is extremely low.
• A safety circuit
• prevents cell damage from overcharge/over-discharge,
• activates when the battery is left in an unused terminal for extended
periods, and
• resets when battery voltage reaches a preset threshold during the charge
cycle.
Refer to Spare Smart Battery Pack for smart battery instructions for the
Omni 3600 terminal on the Omni 3600 base.
Smart Battery Installation
The smart battery installs in a slot on the back of the terminal, as shown in
Figure 4. The locking tab clicks when the battery is in place. The slot is keyed, so
that there is only one way to insert the battery.
Figure 4 Install the Smart Battery
NOTE
Conserve battery power by turning the Omni 3600 terminal off when not in use. If
the terminal is not to be used for several days, remove the battery from the
terminal as it continues to discharge even when the terminal is turned off.
NOTE
The smart battery pack must be installed and holding a minimum of a 1% charge
to operate the Omni 3600 terminal.