User's Manual Part 3

SYSTEM MODE
System Mode Menus
48 OMNI 3600 REFERENCE MANUAL
Table 8 System Mode Menu 3
Display Action
SYS MODE MENU 3
CONFIG INFO F2
EDIT F3
PASSWORDS F4
↑↓
To view terminal configuration information, select
CONFIG INFO F2. To edit the CONFIG.SYS or another
keyed file, or to set the country code for your terminal’s
modem, select
EDIT F3. (For more information, refer to
the Edit Keyed Files section that follows this main
menu description.)
To change the system mode and file group passwords,
select
PASSWORDS F4. The file groups and system
mode all use a default password that is pre-set at the
factory: Z66831. It is entered as:
1 ALPHA ALPHA 6 6 8 3 1 and press [
↵].
To return to the previous system mode menu, press
the PF1 key.
To return immediately to
SYS MODE MENU 1, or to quit
any operation within this menu, press the cancel key.
To toggle to the system mode menu 4, press the PF2
key or [
↵].
CONFIG INFO F2
SYS MODE CONF
RAM FILES 3
INUSE 728
AVAIL 481056
FLASH FILES 0
INUSE 0
AVAIL 786424
↓
This screen shows the number of kilobytes in use and
that available for RAM and flash.
To continue, press the PF2 key.
SYS MODE CONF
RAM 512
FLASH 1024
SERNO K2-0001
PTID 12000000
PART P096-100-02
VERS A
↑↓
This screen shows configuration information specific to
your terminal:
• Total kilobytes of RAM memory
• Total kilobytes of flash memory
• Serial number
• Permanent terminal identification number (PTID)
• Terminal part number
• Terminal hardware version number
Your terminal’s screen may vary depending on your
terminal’s model and the operating system version
installed.
To return to the previous menu, press the PF1 key; to
continue, press the PF2 key.