User's Manual Part 3

SYSTEM MODE
System Mode Menu 5
O
MNI 3600 REFERENCE MANUAL 55
System Mode
Menu 6
In this menu you can run integrated PIN pad (IPP) diagnostics, check the IPP key
loading mode, display printer information, and run printer tests.
Table 11 System Mode Menu 6
Display Action
SYS MODE MENU 6
IPP DIAG F2
IPP KEY LOAD F3
PRINTER DIAG F4
↑↓
To test the IPP, select IPP DIAG F2. To test the IPP key
load, select
IPP KEY LOAD F3. To run printer
diagnostics and test the printer, select
PRINTER DIAG
F4
.
To return to the previous system mode menu, press
the PF1 key; to toggle through to
SYS MODE MENU 7,
press the PF2 key; to return immediately to
SYS MODE
MENU 1
, or to quit any operation within this menu,
press the cancel key.
IPP DIAG F2
INTERNAL PIN PAD
MEMORY TEST PASSED
IPP6 0PGP021 12/99 B6
SN: 00000000000000000000
BAUD: 1200 RESET F3
MODE: VISA
EXIT F4
When you select F2, the INTERNAL PIN PAD screen
appears and the diagnostic test begins. The firmware
version and download date, IPP serial number, baud
rate, and mode display.
To reset the IPP, press F3; to exit the test and return to
SYS MODE MENU 6, press F4 or the cancel key.
IPP KEY LOAD F3
INTERNAL PIN PAD
KEY LOADING MODE
BYTES SENT 0
BYTES RCVD 0
END F4
Select this mode when using SecureKit or
programming from your PC to inject keys into your
terminal. The terminal must be docked to inject keys
using these tools. In this mode, a pipe is opened
through COM1 to the IPP to allow key loading.
Press the cancel key to stop the key load session;
press F4 when finished with the key load.
PRINTER DIAG F4
PRINTER ID M
V
ERSION 0LIT002C
STATUS 20
TEST F3
P
APER F EED
F4
When you select F4, the firmware ID and version, and
the printer status appear.
Press F3 to run the printer test. A print sample begins
that uses approximately 30.5 cm (12”) of paper. This
allows you to test the print quality and adjust your code
for print optimization.
See the Verix Programmer’s Manual for specifics on
application development and the internal thermal
printer.
Press F4 to run approximately 5 cm (2”) of paper
through the printer without printing. To exit this screen,
press the cancel key.