User's Manual Part 4

SYSTEM MESSAGES
OMNI 3600 REFERENCE MANUAL 131
This message displays when you select CONFIG INFO F2 in SYS MODE MENU 3 and press
the PF2 key (below the down arrow) two times. This third display, in a series of
four, provides the following information about the current terminal configuration:
• MODL: The model number assigned to the terminal on manufacture.
• CTRY: The name or abbreviation (up to 42 characters) of the country of
manufacture.
• KEYPAD: A code (0–5) to indicate keypad type.
• DISPLAY: A code (000000, 000001, or xxxyyy) to indicate display unit type.
• MAG RDR: A code (0–4) to indicate magnetic stripe card reader type.
• PRINTER: A code (0 or 1) to indicate that a thermal printer is integrated.
This message displays when you select
CONFIG INFO F2 in SYS MODE MENU 3 and press
the PF2 key (below the down arrow) three times. This fourth display, in a series of
four, provides the following information about the current terminal configuration:
• PINPAD: A code (0 or 1) to indicate that a PIN pad is integrated.
• LIFE: The number of seconds the terminal has run since first powered on.
• RSET: The date and time when the terminal was last reset, in yymmddhhmmss
format.
• RCNT: The total number of times the terminal has been reset.
• MODEM CTRY: The current two-digit modem country code setting. For additional
information about modem country codes, see the Verix Operating System
Programmer’s Manual.
This message displays if you enter an incorrect system mode password or an
incorrect file group password. Repeat the password entry and press the enter key.
MODL O3600M
CTRY GEN
KEYPAD 0
DISPLAY 128064
MAG RDR 3
PRINTER 1
↑↓
PINPAD 1
LIFE 730810
RSET 020829000536
RCNT 198
MODEM CTRY ?
↑↓
PLEASE TRY AGAIN