Installation Guide

OMNI 3600 BASE

Omni 3600 Terminal Docking

MNI 3600 INSTALLATION GUIDE 27

1 Insert the round barrel connector into the power port (icon at left) on the far

right of the Omni 3600 base.

2 Insert the power cable into the power pack.

3 Plug the power cable into a wall outlet or surge protector. When the

Omni 3600 base is powered, the far-right LED (icon at left) lights steady

green.

Omni 3600

Terminal

Docking

Place the Omni 3600 terminal in the docking cradle (Figure 23) to recharge the

terminal smart battery, establish communications connections for data transfers,

and communicate with peripheral devices.

Spare Smart

Battery Pack

Spare smart battery packs for the Omni 3600 terminal can be ordered from

VeriFone. See Accessories and Documentation for ordering information. To

charge a smart battery in the Omni 3600 base, place the smart battery into the

Omni 3600 base spare smart battery dock as shown in Figure 24. The smart

battery dock is keyed so that the smart battery can only be inserted in one way.

Figure 24 Spare Smart Battery Docking

Keep a spare smart battery charging in the Omni 3600 base battery dock to

ensure that a fully charged battery is always available.

NOTE

The Omni 3600 terminal will not turn off or enter sleep mode while docked on the

Omni 3600 base. This ensures that the unit is not placed into sleep mode during

data transfers. The unit must be turned off manually when docked on the

Omni 3600 base. See Turn On/Off the Omni 3600 Terminal.

NOTE

Allow the spare battery to remain in the Omni 3600 base unit for a

minimum of 2 hours, maximum of 4 hours to ensure the battery

receives a full charge. Note that a new Li-ion battery’s full performance

is achieved only after two or three complete charge and discharge

cycles.