User's Manual
Table Of Contents
- Omni 5xxx
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Select Terminal Location
- Unpack the Shipping Carton
- Examine Terminal Features
- Establish Telephone Line Connections
- Install Paper Roll
- Install/Replace MSAM Cards
- Connect Optional Device(s)
- Connect Terminal Power Pack
- Smart Battery
- Install/Replace SIM Card (GSM models)
- Wireless Transactions
- Smart Card Transaction
- Magnetic Card Reader Use
- Antenna (Some Wireless Models)
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
TERMINAL SETUP
Establish Telephone Line Connections
V
E
RI
F
O
NE
C
O
N
F
I
D
E
N
T
I
A
L
R
A
FT
OMNI 5XXX INSTALLATION GUIDE 15
• The RS-232 port, icon shown at right, connects a VeriFone
CR 600 check reader, 1000i check reader, or other peripheral
device.
• The PIN pad port, icon shown at right, connects a external PIN
pad or smart card reader.
• The power connection port uses a round barrel connector. It is
identified by the electrical power icon shown at right. Use this port to
connect the Omni 5xxx to the power pack to recharge the battery
through the unit.
Establish
Telephone Line
Connections
Connect the telephone cord to the communication port on the terminal, then route
it directly to a telephone wall jack (see Figure 4). This is a direct connection, and
the line is dedicated to the terminal.
Figure 4 Direct Telephone Connection
WARNING
Do not connect the terminal to the power supply until all the peripherals are
attached.
WARNING
To reduce the risk of fire, use only No. 26AWG or larger telecommunication line
cord.