User's Manual
Table Of Contents
- Omni 5xxx
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Select Terminal Location
- Unpack the Shipping Carton
- Examine Terminal Features
- Establish Telephone Line Connections
- Install Paper Roll
- Install/Replace MSAM Cards
- Connect Optional Device(s)
- Connect Terminal Power Pack
- Smart Battery
- Install/Replace SIM Card (GSM models)
- Wireless Transactions
- Smart Card Transaction
- Magnetic Card Reader Use
- Antenna (Some Wireless Models)
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
TERMINAL SETUP
Connect Optional Device(s)
V
E
RI
F
O
NE
C
O
N
F
I
D
E
N
T
I
A
L
R
A
FT
OMNI 5XXX INSTALLATION GUIDE 19
4 Remove any previously installed MSAM card by sliding the card from the
MSAM cardholder.
5 Install an MSAM card by aligning the card and carefully sliding it within the
guides on the cover until it is fully inserted (see Figure 10).
Figure 10 Installing An MSAM Card
6 Replace the MSAM compartment door and reinstall the screw (see Figure 11).
Figure 11 Closing MSAM Compartment Door
Connect
Optional
Device(s)
The Omni 5xxx supports some peripheral devices designed for use with electronic
point-of-sale terminals.
NOTE
Before inserting the MSAM card, position it as shown in Figure 10, with the card’s
gold contacts facing the smart car reader end of the terminal. The cardholder
connector base has a set of contacts and a notch on one corner to ensure the
MSAM card is positioned correctly. The MSAM card has a notch on one corner to
ensure that it fits into the connector base in only one way. The MSAM
compartment door will not close properly if the MSAM card(s) are installed
incorrectly.