User's Manual
Table Of Contents
- Omni 5xxx
- Contents
- Preface
- Terminal Overview
- Terminal Setup
- Select Terminal Location
- Unpack the Shipping Carton
- Examine Terminal Features
- Establish Telephone Line Connections
- Install Paper Roll
- Install/Replace MSAM Cards
- Connect Optional Device(s)
- Connect Terminal Power Pack
- Smart Battery
- Install/Replace SIM Card (GSM models)
- Wireless Transactions
- Smart Card Transaction
- Magnetic Card Reader Use
- Antenna (Some Wireless Models)
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
TERMINAL SETUP
Smart Battery
24 OMNI 5XXX INSTALLATION GUIDE
V
E
RI
F
O
NE
C
O
NF
I
D
E
N
T
I
A
L
R
A
FT
Refer to Spare Smart Battery Pack for smart battery instructions for the Omni 5xxx
terminal on the Omni 5xxx terminal.
Smart Battery
Installation
The smart battery installs in a slot on the back of the terminal, as shown in Figure
15. The locking tab clicks when the battery is in place. The slot is keyed, so that
there is only one way to insert the battery.
Figure 15 Install the Smart Battery
Smart Battery
Removal
To remove the smart battery, press the locking tab at the top of the battery and pull
the smart battery from its slot.
Smart Battery
Charging
On initial use, the smart battery must be fully charged and fully discharged
through normal operation. After unpacking your Omni 5xxx terminal, install the
battery and connect the power pack to the unit for 24 hours. Disconnect the power
pack and allow your Omni 5xxx terminal to remain on until the smart battery
completely discharges. Reconnect the power pack to the unit and allow the smart
battery to recharge a maximum of 24 hours.
It is also recommended that the smart battery receive a periodic full discharge. To
ensure a full discharge, use the unit until the battery is fully drained.
To determine the charge state of the battery, push the “test button” icon (shown in
Figure 16) on the bottom of the battery. The bar LED status indicators on the
battery each indicate 25% of the charge state. When the battery charge state
reaches 10%, the
• LED (Figure 16) blinks, indicating a low-charge state. The
battery charge state displays at the bottom of the first copyright screen when the
terminal is turned on.
NOTE
The smart battery pack must be installed and holding a minimum of a 1% charge
to operate the Omni 5xxx terminal.
NOTE
Conserve battery power by turning the Omni 5xxx terminal off when not in use. If
the terminal is not to be used for several days, remove the battery from the
terminal as it continues to discharge even when the terminal is turned off.