User's Manual

SETUP
Optional Accessories
18 P400/P400 PLUS INSTALLATION GUIDE
V
E
R
I
F
O
N
E
C
O
N
F
I
DE
N
T
I
A
L
Performing
Contactless
Transactions
To perform a contactless smart card transaction:
1 Gently tap the card onto or hold the card (within 4 cm) against the surface of
the display.
2 An activated LED visual on the display accompanied by a short beeping sound
indicates a successful transaction.
Optional
Accessories
These accessories can be used to further enhance the device’s functionality. See
Accessories and Documentation for additional information.
Privacy Shield
The privacy shield is used to hide the keys when entering user password in a
transaction.
Installing the Privacy
Shield
To install a privacy shield:
1 Align the hooks on the privacy shield with the corresponding slots beside the
keypad on the terminal.
2 Once the hooks are in place, gently push down on the privacy shield until it
snaps into place.
Stylus and Holder
A stylus with holder can be attached to P400 and used as an alternative device
input method.
Attaching the Stylus
Holder
To attach the stylus:
1 Align the stylus holder’s screw holes with those found on the back of
the terminal.
2 Screw the holder onto the back of the terminal as shown in the illustration
below:
Mounting Adapter
This accessory is used to mount P400 to vertical or inclined surfaces.
Attaching a Mounting
Adapter to P400
To attach a mounting adapter to P400:
1 Align the screw holes at the back of the terminal with the corresponding
screws on the mounting adapter (this can be done with or without the stylus
holder attached).
2 Screw the mounting adapter in place while keeping the terminal aligned with
the mounting adapter.
Mounting P400 with
Mounting Adapter to
a Wall or Flat Surface
To mount the terminal to a wall or flat surface:
1 Ensure the mounting adapter is attached to the terminal.
2 Attach three M3 screws (not included in P400 package) to the desired surface.
Make sure that they are aligned with the slots on top and at the bottom of the
mounting adapter.