User's Manual

QX100
Installation Manual 15
8. Mounting the Contactless Reader
The QX100 is able to lie flat, at a 180° angle, with two key holes
on the bottom panel for mounting the reader on a wall.
To mount the QX100:
1. Drill two holes in the wall for screws, with a 5.5 cm
(2.165 in) between them, according to the drilling pattern.
2. Insert wall inserts with screws.
3. Adjust the mounting screw heads until they are firmly in
place.
4. Take the reader and face the bottom of the base towards
the wall, with the narrow part of the key hole facing
upwards.
5. Push the base, so that the mounting holes at the bottom of
the base are around the screw heads.
Note
When mounting the contactless reader, it must be
close enough to the POS terminal or ECR, for the
connecting cables, and in an easily accessible location
for the customer.
Note
The recommended screws for mounting the QX100 are
flat head screws with a thread diameter of
approximately 4 mm (0.157 in) and head diameter of
approximately 8 mm (0.315 in).
Note
The manual includes a drilling pattern in the back, for
your convenience.
DRAFT