Installation Guide

SETUP
Installing or Replacing SAM Cards
UX300 M
ANUAL CARD READER INSTALLATION GUIDE 15
• PSTN
• ISDN
• RS-485
• Printer COM
• PSTN_RJ9
• 485_3pin
Top Functions • SAM cardholder cover
• Additional service switch
Installing or
Replacing SAM
Cards
You may need to install a security access module (SAM) card or replace the old
card. The manual card reader and controller has 2 (two) SAM slots, which are
located under a removable protective cover.
To install or replace
SAM cards
1 Power down the device.
2 Disconnect the device from any external devices.
3 Gently slide the SAM cardholder cover away from the unit, off the top panel.
Figure 4 Removing the SAM Cardholder Casing
4 Open the SAM cardholder, by sliding the locking tab towards the back of the
unit, to the
OPEN position.
NOTE
Some or none of the model-dependent may be present on your unit and in the
model depicted in Figure 2.
CAUTION
Observe standard precautions in handling electrostatically sensitive devices.
Electrostatic discharges can damage the equipment. VeriFone recommends
using a grounded anti-static wrist strap.