Installation Guide
Table Of Contents
SETUP
Cable Connections
18 UX300 MANUAL CARD READER INSTALLATION GUIDE
Connect the appropriate cable to the UX300 unit and the other end to the media
display.
Connecting to a PC
The UX300 unit is designed to connect to a host PC through one of three
connection ports:
• RJ-45–-RS-232 connection
• USB Type B connection
• LAN connection
Connect the appropriate cable to the UX300 unit and the other end to the PC unit.
For more information regarding your card reader configuration and your cabling
needs, contact your local VeriFone service provider. For cable ordering
information, see Accessories and Documentation).
Connecting to a UX-
Series Peripheral
Device
This section discusses the connection of the UX300 device with the following
peripheral units:
• Connecting to a UX1XX PIN Pad
• Connecting to a UX200 Media Display Unit
• Connecting to a UX400 CTLS Unit
Connecting to a
UX1XX PIN Pad
The UX300 unit is designed to connect to a UX1XX PIN pad device through a
standard USB Type A connection.
Connect the USB cable to the UX300 unit and the other end to the PIN pad.
For further cabling instructions, see Figure 7.
Figure 7 Connecting to a UX Series PIN Pad
NOTE
The UX300 connects to the UX200 media display as both a host, as well as a
peripheral device. To see how to connect to the UX200 as a peripheral device,
see Connecting to a UX-Series Peripheral Device.