Installation Guide

SETUP
Mounting the Device
UX300 M
ANUAL CARD READER INSTALLATION GUIDE 21
External Power
Connections
The UX300 connects to an external power outlet through a 4-pin interconnect
cable (VPN - CBL159-308-01-A) or a 6-pin interconnect cable
(CBL159-309-01-A). The connection depends on your specific card reader
configuration.
For more information regarding your card reader configuration, contact your local
VeriFone service provider. For cable ordering information, see Accessories and
Documentation).
To connect to an
external power outlet
Connect the 4- or 6-pin interconnect cable to the external power port on your
device and the other end to an external power outlet.
Figure 9 Sample Connection to an External Power Source
Mounting the
Device
The card reader and controller is designed to be flush-mounted to the mounting
surface, without further need for any external mounting devices.
To mount the unit
1 Peel off the plastic liner from the front of the unit.
2 Align the reader’s stud holes with the holes of your mounting surface.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, VeriFone recommends installing a power surge protector.
CAUTION
For proper operation of the security switches, no additional gaskets or washers
may be used, except for the ones provided to you.
Ensure that your mounting frame has a thickness of 2 mm.
NOTE
Your mounting surface may have different installation instructions. Refer to your
mounting device’s user guide for further instructions.