User's Manual
Table Of Contents
- V200 Non-Touch Installation Guide
- Contents
- Preface
- Device Overview
- Setup
- Selecting Unit Location
- Unpacking the Shipping Carton
- Examining the Unit’s Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing or Replacing MSAM Cards
- Connecting Optional Devices
- Connecting the Terminal Power Pack
- Privacy Shield
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Periodic Inspection
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Port Pinouts
- Caution and Warning Messages
- Contact Verifone
SETUP
Loading a Paper Roll in the Printer
22 V200 NON-TOUCH INSTALLATION GUIDE
5 Drop the paper roll into the printer tray.
Figure 9 Loading Paper Roll
6 Pull paper up past the glue residue.
7 Close the paper roll cover by gently pressing directly on the cover until it clicks
shut, allowing a small amount of paper past the glue residue to extend outside
the printer door. (see Figure 9).
Figure 10 Closing Paper Roll Cover
8 Tear the paper off against the serrated metal strip in the printer.
)MAGE0LACEHOLDER/NLY
#ORRECT)LLUSTRATIONS#OMING3OON
CAUTION
To prevent the paper roll cover from damaging the print roller, always gently
press down on the printer dust cover to close it.
)MAGE0LACEHOLDER/NLY
#ORRECT)LLUSTRATIONS#OMING3OON
NOTE
For paper ordering information, refer to Accessories and Documentation.