User's Manual

SETUP
Connecting Optional Devices
24 V200 NON-TOUCH INSTALLATION GUIDE
Connecting
Optional
Devices
The V200 Non-Touch device supports some peripheral devices designed for use
with electronic point-of-sale terminals.
Different terminals support different devices, so for more information about
optional devices, please contact your Verifone distributor.
Optional Device
Connections
The MOD 10 2-in-1 I/O port can operate either as a PIN pad port or an RS-232
port, depending on the power source available.
Connecting a PIN Pad
to the V200 Non-
Touch
Use the following procedures to connect a PIN pad or smart card reader.
1 Remove the V200 Non-Touch rear cover.
2 Insert the RJ45-type connector of the PIN pad or smart card reader into the
port of the peripheral device.
If a cable is not already connected to the smart card reader or PIN pad, insert
the small modular plug on one end of the interface cable into the optional
device’s modular jack.
3 Insert the larger RJ45-type connector on the other end of the PIN pad cable
into the PIN pad serial port on the V200 Non-Touch. Figure 13 provides an
example of a PIN pad connection to the V200 Non-Touch.
Figure 13 Sample PIN Pad Connection
Connecting ECRs to
the V200 Non-Touch
The V200 Non-Touch also supports electronic cash registers (ECR).
CAUTION
Before connecting any peripheral device, remove the power plug from the
terminal. Reconnect the power cord only after you are finished connecting the
peripheral device(s). For complete information about peripheral installation and
use, refer to the user documentation supplied with those devices.
)MAGE0LACEHOLDER/NLY
#ORRECT)LLUSTRATIONS#OMING3OON
NOTE
Make sure you replace the rear cover when all cables are installed. This provides
some protection to the cables and connectors. Do not carry the terminal by the
installed cables or pull the terminal about the by the cables. This may cause a
cable to be removed or damage the cables.