User's Manual
Table Of Contents
- V200 Non-Touch Installation Guide
- Contents
- Preface
- Device Overview
- Setup
- Selecting Unit Location
- Unpacking the Shipping Carton
- Examining the Unit’s Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing or Replacing MSAM Cards
- Connecting Optional Devices
- Connecting the Terminal Power Pack
- Privacy Shield
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Periodic Inspection
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Port Pinouts
- Caution and Warning Messages
- Contact Verifone
SETUP
Connecting the Terminal Power Pack
26 V200 NON-TOUCH INSTALLATION GUIDE
2 Insert the round barrel connector (see Figure 15) into the power port.
Figure 15 Power Connection
3 Route the cable in the direction of the arrow above the power port and sling
the cable over the underside of the thermal paper container.
4 Close the terminal rear cover.
5 Plug the AC power pack into a wall outlet or powered surge protector.
The terminal lights activate when the terminal has power.
If an application is loaded in the terminal, it starts after the initial Verifone copyright
screen and usually displays a unique copyright screen. If no application is loaded
in the terminal,
DOWNLOAD NEEDED appears on screen after the initial Verifone
copyright screen.
WARNING
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
Disconnecting the power during a transaction may cause transaction data files
not yet stored in terminal memory to be lost.
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
NOTE
Verifone recommends connecting wall power in the following order:
1 Connect the terminal to the power supply.
2 Connect the power supply to the power cord (if applicable).
3 Connect the power cord to the wall outlet.