User's Manual
Table Of Contents
- V200 Non-Touch Installation Guide
- Contents
- Preface
- Device Overview
- Setup
- Selecting Unit Location
- Unpacking the Shipping Carton
- Examining the Unit’s Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing or Replacing MSAM Cards
- Connecting Optional Devices
- Connecting the Terminal Power Pack
- Privacy Shield
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Periodic Inspection
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Port Pinouts
- Caution and Warning Messages
- Contact Verifone
SETUP
Using the Magnetic Card Reader
28 V200 NON-TOUCH INSTALLATION GUIDE
To conduct a smart
card transaction
1 Position a smart card with the contacts facing upward (see Figure 18).
2 Insert the smart card into the smart card reader slot in a smooth, continuous
motion until it seats firmly.
3 Remove the card only when the application indicates the transaction is
complete.
Figure 18 Inserting a Smart Card
Using the
Magnetic Card
Reader
The V200 Non-Touch terminal supports credit or debit card transactions.
To conduct a credit or
debit card transaction
1 Position the card with the stripe in the card reader and facing inward, toward
the keypad.
2 To ensure a proper read of the magnetic swipe card, the user should insert the
magnetic card from the top of the unit, as shown in Figure 19.
Figure 19 Using the Magnetic Card Reader
3 Swipe the card through the magnetic card reader.
)MAGE0LACEHOLDER/NLY
#ORRECT)LLUSTRATIONS#OMING3OON
CAUTION
Leave the smart card in the card reader until the transaction is complete.
Premature card removal will invalidate the transaction.
)MAGE0LACEHOLDER/NLY
#ORRECT)LLUSTRATIONS#OMING3OON