User's Manual
Table Of Contents
- V200 Non-Touch Installation Guide
- Contents
- Preface
- Device Overview
- Setup
- Selecting Unit Location
- Unpacking the Shipping Carton
- Examining the Unit’s Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing or Replacing MSAM Cards
- Connecting Optional Devices
- Connecting the Terminal Power Pack
- Privacy Shield
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Periodic Inspection
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Port Pinouts
- Caution and Warning Messages
- Contact Verifone
SPECIFICATIONS
Technical Specifications
32 V200 NON-TOUCH INSTALLATION GUIDE
• Dial modem
• Modem: Conexant Boulevard CX93040-1X
• DAA: Conexant CX20548
• Host interface SPI
• V.92 standard supported, line speeds from 2400 Kbps to 56 Kbps.
• USB
• USB2.0 high speed
• USB Host/Device configurable by SW
• Supports 5 V/500 mA to external USB device.
• MOD 10 2-in-1 I/O port
• Integrates RS-232, USB2.0 Host / Device IO ports into a 10-pin RJ45
connector.
• Uses VFI customized extension cable to access USB host port or USB
device port. The extension cable is not a standard in-box accessory.
• Supports Biometrics and Barcode reader via MOD 10 connector.
Display
• 2.8 inch portrait mode transmissive TFT LCD, RGB stripe (QVGA, 240 RGB x
320 dots)
• RGB data bus interface, 18 bit Parallel Data
• Software controllable back-light
• SPI interface for LCM controller.
Thermal Printer
• Support 30 LPS for first 30 sec, and then printing speed will slow down to
meet 18 W power budget.
• Supports 57 mm wide x 40 mm diameter paper roll
• Out-of-Paper Sensor.
SD Memory (Media
version only)
• 4 bit SDIO interface
• Up to 192 Mbps in High-Speed SD mode, 4 bit data transfer
• Supports card detect and write protect
• Speed Class: SDHC Class 2, 4, 6 and 10