User's Manual
Table Of Contents
- V200 Non-Touch Installation Guide
- Contents
- Preface
- Device Overview
- Setup
- Selecting Unit Location
- Unpacking the Shipping Carton
- Examining the Unit’s Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing or Replacing MSAM Cards
- Connecting Optional Devices
- Connecting the Terminal Power Pack
- Privacy Shield
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Periodic Inspection
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Port Pinouts
- Caution and Warning Messages
- Contact Verifone
SETUP
Installing or Replacing MSAM Cards
V200 N
ON-TOUCH INSTALLATION GUIDE 23
Installing or
Replacing MSAM
Cards
When you first receive your V200 Non-Touch, you may need to install one or more
MSAM cards or you may need to replace old cards.
To install or replace
MSAMs
1 Remove the power pack from the power outlet.
2 Place the terminal upside down on a soft, clean surface to protect the display
from scratches.
3 Press the unlocking button and then lift the rear cover to access the MSAM
card slots.
Figure 11 Opening the V200 Non-Touch Rear Cover
4 Remove any previously installed MSAM cards by sliding the card out from the
cardholder.
5 Install an MSAM card by carefully sliding it into the slot until it is fully inserted.
Figure 12 Installing an MSAM Card
6 Replace the terminal rear cover.
CAUTION
Observe standard precautions when handling electrostatically sensitive devices.
Electrostatic discharges can damage this equipment. Verifone recommends
using a grounded anti-static wrist strap.
1
2
3
A
B
3!-