User's Manual
Table Of Contents
- V200 Non-Touch Installation Guide
- Contents
- Preface
- Device Overview
- Setup
- Selecting Unit Location
- Unpacking the Shipping Carton
- Examining the Unit’s Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing or Replacing MSAM Cards
- Connecting Optional Devices
- Connecting the Terminal Power Pack
- Privacy Shield
- Using the CTLS Reader
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Periodic Inspection
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Port Pinouts
- Caution and Warning Messages
- Contact Verifone
SETUP
Privacy Shield
V200 N
ON-TOUCH INSTALLATION GUIDE 27
Privacy Shield
The privacy shield protects the customers’ PIN entry from being seen by the
cashier or other customers. The illustration (Figure 16) shows an example of a
V200 Non-Touch unit with a privacy shield.
Figure 16 Privacy Shield
Using the CTLS
Reader
The V200 Non-Touch function is only active when signaled by an application for
the conduction of a contactless smart card transaction.
To perform a
contactless smart
card transaction
1 Gently tap the card onto or hold the card (within 4 cm) against the surface of
the RFID canopy (see Figure 17).
2 A short beeping sound indicates a successful transaction.
Figure 17 Using a CTLS Card
Using the Smart
Card Reader
The smart card transaction procedure may vary from one application to another.
Verify the procedure with your application provider before performing a smart card
transaction.
)MAGE0LACEHOLDER/NLY
#ORRECT)LLUSTRATIONS#OMING3OON
NOTE
Merchants who install the terminal without the privacy shield must ensure the
cardholder’s privacy when entering his PIN by positioning the terminal away from
open view.
)MAGE0LACEHOLDER/NLY
#ORRECT)LLUSTRATIONS#OMING3OON
NOTE
Follow proper care procedures to ensure the contactless module continues
working properly. Avoid exposing the module to metallic surfaces while in use.