User's Manual

SETUP
MSAM, Micro SD and SIM Cards
16 V400M PLUS 3G & V400M BASES INSTALLATION GUIDE
V
E
R
I F
O N
E
C
O
N
F I
D
EN
T
I
A
L
4 Replace all the packing materials, close the lid, and save the carton for
repacking or moving the V400m Plus 3G & V400m Bases unit in the future.
MSAM, Micro SD
and SIM Cards
You may need to install or replace the multiple security access module (MSAM),
Micro Secure Digital (SD) and Subscriber Identity Module (SIM) cards.
Accessing Card
Compartments
Use the following procedure in order to access the cardholder compartment.
1 Place the terminal face down on a soft and clean surface to protect the lens
from scratches.
2 Slide to unlock and lift the compartment cover.
3 Remove the battery to access the MSAM cardholders.
Figure 5 How to Access Cardholders
Changing or
Installing MSAMs
To change or install MSAM cards:
1 Use steps 1 to 3 of Accessing Card Compartments to get to the MSAM
cardholder.
2 Unlock the cardholder and turn upwards to allow the insertion or removal of
cards.
WARNING
Do not use a unit that has been tampered with or otherwise damaged. This unit
comes equipped with tamper-evident label. If a label or component appears
damaged, immediately notify the shipping company and your Verifone
representative or service provider.
C
1
2
CAUTION
Observe standard precautions in handling electrostatically sensitive devices.
Electrostatic discharges can damage the equipment. Verifone recommends using
a grounded anti-static wrist strap.
NOTE
The V400m Plus 3G & V400m Bases supports two MSAM cards in a side-by-side
configuration.