Installation guide
TERMINAL SETUP
VX 520 Setup
VX 520 I
NSTALLATION GUIDE 25
To install or replace
MSAMs
1 Remove the power cord from the power outlet.
2 Place the terminal upside down on a soft, clean surface to protect the display
from scratches.
3 Press the unlocking button and then lift the rear cover to access the MSAM
cardholder panel.
Figure 11 Opening VX 520 Rear Cover
4 Hold the MSAM cardholder panel, grasp firmly and pull upward to expose the
MSAM slots.
Figure 12 Removing MSAM Cover
4 Remove any previously installed MSAM card by sliding the card from the
MSAM cardholder.
23
%4(
23
%4(