Specifications

PERFORMING DOWNLOADS
Set Up the Download Environment
120 VX 520 REFERENCE GUIDE
2 Confirm that the parameters for the download by telephone are set in the
download tool.
3 Confirm that the receiving VX 520 terminal has a direct telephone line
connection.
4 Ensure that the correct keyed variables used to control downloads by
telephone are stored in the CONFIG.SYS file of the target file group on the
receiving terminal.
Cable Connection
for Back-to-Back
Application
Downloads
To prepare for a back-to-back application download:
1 Insert the RJ-45 modular connector on one end of the download cable
(VPN 05651-00) into the RS-232 port of the sending terminal.
2 Insert the RJ-45 connector on the other end of the cable into the RS-232 port
on the back panel of the receiving terminal.
3 Power up both terminals.
Common Steps to
Start a Download
After setting up the appropriate cable connections, power up the terminal and
initiate the downloading session. Table 17 guides you through the common steps
when initiating a download. Procedures specific to a download type is discussed
in the later sections.
Table 17 Common Steps to Start a Download
Step Display Action
1
VERIFONE VX 520
QT00E20B
12/22/2009 Verix
COPYRIGHT 1997-2009
VERIFONE
ALL RIGHTS RESERVED
At startup, the terminal displays a copyright
notice screen that shows the terminal model
number, the OS version of the VX 520 stored
in the terminal’s flash memory, the date the
firmware was loaded into the terminal, and the
copyright notice.
This screen appears for three seconds, during
which time you can enter Verix Terminal
Manager by simultaneously pressing F2 and
F4.
You can extend the display period of this
screen by pressing any key during the initial
three seconds. Each keypress extends the
display period an additional three seconds.