Specifications

VERIX TERMINAL MANAGER
Verix Terminal Manager Menus
62 VX 520 REFERENCE GUIDE
5> DIAGS
VERIX DIAGS MGR
1> Printer Diag
2> IPP Diag
3> ICC Diags
4> Keyboard Diag
5> Mag Card Diag
6> Debugger
↓↑↓
To choose an option in the menu, press the
corresponding number on the keypad or scroll down to
the option using the PF3 button then press . Use
the PF4 key to scroll up the menu options.
To run printer diagnostics and test the printer, select
1> PRINTER DIAG.
To test the internal PIN pad, select
2> IPP DIAG.
To test the Smart Card and list synch drivers, choose
3> ICC DIAGS.
To test the keyboard, select
4> KEYBOARD DIAG.
To check the magnetic card swipe, choose
5> MAG CARD DIAG.
To debug the terminal, select
6> DEBUGGER.
To return to the second menu of the
VERIX TERMINAL MGR or quit any operation within this
menu, press .
5> DIAGS 1 > PRINTER DIAG
Printer ID P
Version 0PRED1A1
Status 22
1> Test
2> Paper Feed
↑↓
When you select 1> PRINTER DIAG, the printer ID,
firmware version, and the printer status appear.
Press 1 to run the printer test. A print sample begins
that uses approximately 30.5cm (12 in) of paper. This
allows you to test the print quality and adjust your code
for print optimization.
See the Verix V Operating System Programmers
Manual (VPN 23230) for specifics on application
development and the internal thermal printer.
Press 2 to run approximately 5cm (2 in) of paper
through the printer without printing. To go back to the
VERIX DIAGS MGR screen, press .
5> DIAGS 2 > IPP DIAG
INTERNAL PIN PAD
MEMORY TEST PASSED
IPP8 EMUL02A 05/08 01
SN: nnnnnnnnnnnnnnnnn
1> RESET00
MODE: VISA
2> EXIT
When you select 2, the INTERNAL PIN PAD screen
appears and the diagnostic test begins. The firmware
version and download date, IPP serial number, baud
rate, and mode are displayed.
To reset the IPP, press 1; to exit the test and return to
the
VERIX DIAGS MGR screen, press 2 or .
Table 9 Verix Terminal Manager Menu 2
Display Action