User manual

2 Verix SEPT410 & XEPT410 User Manual Installation
CONFIDENTIAL – Chase Paymentech Solutions, LLC – CONFIDENTIAL
Connecting the Cat5 Cable for Ethernet Processing
To connect terminals with a Cat5 Cable:
1. Connect one end of the Cat 5 Cable to the Ethernet port on the terminal.
2. Connect the other end of the Cat 5 Cable to the Ethernet wall jack or
router.
Note: The Vx520 is labeled ETH.
Connecting the Power Pack
Warning! Do not plug into an outdoor outlet or operate the terminal outdoors. Operating
the terminal in direct sunlight may damage the terminal, as can other outdoor factors. Do
not unplug the terminal while processing a transaction. Doing so may cause transaction
errors within the terminal or at the host.
1. Plug the AC power cord into an indoor AC outlet.
2. If not already attached, plug the AC power cord into the AC
adapter.
3. Attach the small plug on the AC adapter cord to the power port
on the rear of the terminal.
Note: The Vx820 comes with a 1 piece power pack.
Installing a Paper Roll
1
2
3
To install a roll of paper:
1. Vx510-DC: Open the printer cover by pressing down on the release on the right side of the terminal
Vx520: Open the printer cover by pulling the release on the top of the cover.
2. Hold the roll of paper with the leading end coming from the bottom of the roll and pointing toward the
front of the terminal then place into the paper roll cradle.
3. Close the printer cover making sure the leading edge of the paper remains on the outside, and that
the lid has snapped down securely.
Note: Pressing the 3 key from SoftPay will feed the paper.